Dryer drum support roller kit. Includes two washers. When the drum rollers are worn out, they can cause the dryer to make a loud rumbling noise. Both rollers should be replaced at the same time. The roller does not need lubrication, the bearing is self-lubricating.

OEM Part - Manufacturer #12001541

Dryer drum drive belt, 100 inches long, 3/8" wide,5 ribs 4 grooves. The drive belt wraps all the way around the dryer drum, around a tension pulley, and then around the drive motor pulley. If the drum will not turn when the dryer is turned on the belt is likely broken.

OEM Part - Manufacturer #WPY312959

Make sure the belt is aligned on the high part of the drum. If it is riding in the groove it will rub on the idler pulley guide arm.

Dryer blower wheel for exhaust with clamp. If the dryer does not heat properly then this wheel may be stripped causing an air flow problem.

OEM Part - Manufacturer #Y303836

Dryer drum roller axle. If the dryer is noisy this roller axle or the roller itself may be worn and require replacement.

OEM Part - Manufacturer #WP6-3129480

Dryer front drum support glide. Order 2 when repairing the dryer. Be aware it requires a rivet tool to install the new glide and the tool must be purchased locally.

OEM Part - Manufacturer #306508

Consider replacing the drum support rollers while you have the dryer apart as they wear out over time.

Dryer slide in lint filter (lint trap). Proper air flow is critical to dryer operation so the filter should be cleaned before every load. Replace the filter if it has any tears or rips in it.

OEM Part - Manufacturer #WP33001003

Washer belt kit for Maytag models. If the washer does not agitate, spin, or drain then one of the belts could be worn and require replacement. Belt sizes: 41 in x 5/16 in, 42-1/3in by 7/16 in

OEM Part - Manufacturer #12112425

High temperature adhesive for installing rubber feet and felt seals, 2 ounces.

OEM Part - Manufacturer #WPY055980

White silicone adhesive caulk. Forms a heat resistant bond. Often used for gaskets, seals and burner grate feet.

OEM Part - Manufacturer #W10841140

Dryer igniter with wire harness connecter. This is a flat-style igniter. The igniter uses heat to ignite the gas in the burner assembly. If the igniter is defective, the gas will not ignite and the dryer will not heat.

OEM Part - Manufacturer #4391996

Gas dryer sensor for igniter and flame. The sensor is located across from the gas igniter at the dryer’s burner assembly. This flame sensor should be closed for continuity at room temperature. Check for continuity with a multi-meter before replacing.

OEM Part - Manufacturer #WP338906

Dryer idley pulley. The idler pulley puts tension on the drive belt. If the idler pulley fails to put the proper amount of tension on the belt, the dryer will not spin.

OEM Part - Manufacturer #WP6-3037050

Dryer door catch kit. Includes door catch and clip (plastic)

OEM Part - Manufacturer #306436