Jenn Air Dryer Parts

Dryer drum drive belt. The belt is flat, 92-1/4 inches long, 1/4 inch wide and has 4 ribs and 3 grooves. It replaces many other belts, including some with 5 ribs and 4 grooves. If the drum does not turn, but you can hear the motor running then there is a good chance the belt has broken.

OEM Part - Manufacturer #341241

Consider replacing the idler assembly while you have the dryer apart.

Dryer gas burner valve solenoid set. If the dryer does not heat or heats intermittently the coils could be defective. To test, watch the burner and if the igniter glows for a while and then shuts off without the gas igniting, it usually means one of these coils is bad.

OEM Part - Manufacturer #279834

Snap retaining ring

OEM Part - Manufacturer #WP9703438

Self-tapping screw.

OEM Part - Manufacturer #WP489483

Gas dryer sensor for igniter and flame. The sensor is located across from the gas igniter at the dryer’s burner assembly. This flame sensor should be closed for continuity at room temperature. Check for continuity with a multi-meter before replacing.

OEM Part - Manufacturer #WP338906

Dryer thermal fuse and high limit thermostat kit for both gas and electric models. If the dryer does not heat then the thermal fuse may have blown and will need to be replaced.

OEM Part - Manufacturer #LA-1053

The thermal fuse often blows when the exhaust vent gets clogged with lint. The vent should be cleaned once a year especially if it is longer than 15 feet.

Dryer lint filter (lint trap). Your lint filter should be replaced if it is torn or damaged in any way.

OEM Part - Manufacturer #WP53-0918

Dryer blower wheel, 3-1/8" deep, 8" in diameter, 7-1/8" hub diameter, 20 standard fins, ½" diameter motor shaft, 3/8" motor shaft diameter to flat side of shaft. If more than one blower wheel is listed with your model, call us with your model and serial number to verify the part.

OEM Part - Manufacturer #31001317

Dryer drum support roller kit with axles and mounting screws. The kit has been updated; it has 1 plastic spacer that is the same thickness of 2 old spacers.

OEM Part - Manufacturer #LA-1008

Consider replacing the drum belt while the dryer is apart.

Door catch kit, includes catch and clip (metal)

OEM Part - Manufacturer #LA-1003

Top screw

OEM Part - Manufacturer #WP3196164

Screw, 10-24 3/8

OEM Part - Manufacturer #WP90767

Blower wheel clamp

OEM Part - Manufacturer #WP312967

Heating element assembly with replacement high limit thermostat, L248-80 (240 Volt, 4750 Watt). Dryer Heating element. If the dryer does not heat check for a blown thermal fuse or thermal cut out. Heating elements will often have a break in the coil element if defective.

OEM Part - Manufacturer #LA-1044